Patrol Table Plans

These plans are based upon several designs used by troops in our council.

Note: the materials list shows how to cut all of the pieces out of one 4' x 8' sheet of 5/8" plywood. The plywood should be exterior grade with one smooth sanded surface. All cut edges need to be sanded. The cleats should be fastened with waterproof glue and rust resistant screws. A good penetrating oil finish will further prevent splinters and improve the life of the table.

Return to top.

Materials:

  • 4'x8' sheet of 5/8" exterior plywood with one smooth sanded surface.
  • Exterior penetrating finish
  • 1" Rust resistant screws
  • Waterproof glue

Notes:

  1. When cutting top support you may use an 8 inch radius for the curved section.
  2. Bench Supports have a 2"x5/8" slot for legs centered 2 11/16'" from each end.
  3. Legs have a 2"x5/8" slot for bench supports centered 2 11/16" from each end.
  4. Legs have a 5"x5/8" slot for the top support centered in top.
  5. Top support has 7"x5/8" slot for legs centered 2 11/16" from each end.
  6. Legs have a 1"x5/8" notches to lock the benches in place.
  7. The cleats are positioned to keep benches and top from sliding.
  8. Fasten the cleats in place with rust-resistant screws and water-proof glue.
  9. Finish with a nontoxic penetrating exterior finish.

Directory to Contents of Henning's Scouter's Pages

Visit Henning's Scouters' Home Page

Visit Henning's Home Pages

Visit Henning's Rhododendron and Azalea Pages

 
ARS Medal
 

Compatibility & Webmaster information: These pages were created in Adobe GoLive, Adobe DreamWeaver, and BBEdit by . They have been successfully tested on computers, ipads, ipods, & iphones and with various browsers including Chrome, Firefox, Internet Explorer, Netscape, OmniWeb, Opera, & Safari. They have also passed the internet standards of the W3C validator tests. They are now translated into over 60 other languages by Google. Please report any problems to .Valid HTML 4.01 Transitional